Off Roading Pix...
Interesting things to do with a Landie and some mud

This page may take a little while to load due to the large number of graphics:- please be a bit patient!

Use the navigation bar below to select the section you'd like to see.



Gently dipping a toe in to test the water temperature,
Mari gingerly eases her way through this mild axle-twister at Tixover
 

 



HMS Landie on yet another voyage of discovery...
As long as you keep a constant speed and allow the bow wave to build properly,
the engine stays remarkably dry, unlike my feet in the very wet foot wells

 

 

Mari navigates around the nursery section at Tixover

 

 

Oink! Oink! Whose next at the trough then?
And no, I wasn't stuck, just parked. I later drove away unassisted to get stuck somewhere else!
The Michelin tyres (UK Army spec) I fitted really make short work of any mud sections.
They are superb on rock too.

 

 

On the Ridgeway, check out the rear axle articulation with those pair-a-bollocks springs!
Unlike the Michelins above, these re-tread tyres were OK, but you have to work a little harder.

 

 

Oi! I can see your diff from here! The parabolic springs make such a difference to axle articulation, otherwise impossible obstacles become much easier.

 

 

HMS Landie makes the return voyage.
The engine was quite dry and never faltered once through this crossing.
I don't have a snorkel, but with the Kenlowe electric fan (switched off!)
and not having a constantly turning engine fan, the water doesn't get splashed about as much.

 

 



Water seeping up through the foot wells, and in through the door seals
meant we were almost up to our knees in water during this and several other
river crossings. This wasn't the deepest, but was the only one my naviguesser got a photo of!

 

 



This doesn't look hard, but the slope is about 40 degrees, and was about as steep
as the landie (2.25 petrol remember) was going to tackle given the weight it was
carrying that day. You can see by the state of the rear wheel that the suspension got a very hard time.

It was because of this hammering I fitted the parabolic springs on returning home.

 

 

28.jpg (92977 bytes)

This is the same obstacle viewed from the side, it begins to show the tricky nature of this trail...

 

 



And here from behind, we only just made it over this!

 

Use the navigation bar below to select the section you'd like to see.



click on the wombat to return home...